Toolbox Home | About the Toolbox | Suppliers

Post Driving and Extracting

Subcategories

No more subcategories found.

Products

Long steel ‘T’ post being driven into the ground by two male adults

Air-Powered Post Driver

Left pic of skid steer with DAnuser T3 Post-Driver Attachment putting a post into the ground. Rt pic of the Post-Driver Attachment.

Danuser T3 Post Driver Attachment

Ready to drill a post hole is the large. bullet-shaped auger affixed to its hydraulic power source that’s connected to arm of a four-wheeled skid steer.

Dirtless Wobble Auger

Attached to the tractor’s 3-point-hitch arm (and in the process of digging a post hole) is the device consists of the auger and above it the motor housing.

Earth Auger

Man digging a hole in the ground with an Earth Auger Torque Reducing Tool.

Earth Auger Torque Reducing Tool

With his hand grasping the handle on each side of the driver

Hand-Held Gas-Powered Post Driver

Seen is an adult male on his knees pumping the device’s internal hydraulic-pump lever which ratchets up a square wooden post that’s collared to the device.

Hand-Operated Hydraulic Post Puller

Pictured is the vehicle-hitched

Heavy-Hitter Post Pounder

The device being 6 inches from the post with one end of the chain affixed to its jaw and the other end wrapped around the post’s base

Hi-Lift Manual Wood-Post Popper

A color cut-away drawing showing the crossbeam affixed to the loader-mounted pallet forks onto which is affixed the cylinder and clamp that will tighten around the post.

Homemade Fence Post Puller

Color drawing of white driver made of vertical angle-iron with a square flat cap welded on top - a round handle welded just below the top - & a footstep welded at the bottom. An orange electric fence post is shown next to it with yellow insulator.

Homemade Post Driver for Electric Fences

Pictured along with its components (hose

Hydraulic-Powered Post/Pole Puller

Pictured is the device

JackJaw Stake Extractor

Being pulled out of the ground by the skid-steer-attached device is a tall

Lobo Skid-Steer Post Puller

Pictured is an adult male

Man-Saver Pneumatic Post Driver

Pictured is the tool consisting of the engine surrounded by metal frame with handholds and an activating lever all atop a 3-foot

One-Person Gas-Powered Earth Auger

The post-driver unit (not attached to the tractor or skid steer) encased over a square wooden fence post

Post-Vibe Vibrating Post Driver

No Longer Produced

With his hands on the left and right U-shaped grippers at the top of the 3-foot tool affixed to the T-post

PostMate T-Post Driver/Puller

The post-driver unit front-mounted on a teleloader with the steel tube above one of the two round wooden posts that has just been driven into the ground.

Postpuncher Post Driver

Artist’s rendition of the device (as described) having soaked the post’s concrete-footing hole

Sawyer Manual Wood-Post Remover

Green metal fence post slanting up from lft to rt used to hold wire fencing with small step just above portion that goes into ground. Below it on rt is metal rod style post with at top to pass wire through and step to push into the ground.

Step-In Fence Posts

Silver T-Post-Pulla Extraction Tool hanging from a loader bucket.

T-Post-Pulla Extraction Tool

Seen behind the tractor is the unit with stabilizers on the right and in the middle

Tractor-Hydraulics-Powered Post Driver

Wheeled post-hole digger with a man at the controls digging a hole in a field

Wheeled Post-Hole Auger